Installation
6-3
Location
Shipping material/Procedure
Check
1
2
3
6.3 Installation procedure
Remove all shipping materials/tape before installation.
Caution : Make sure the copier is unplugged before the installation.
Install the hinge positioning screws
onto upper rear cover of the copier.
(2 shoulder screws)
Note: The hinge positioning screw for
the paper feed side should uti-
lize the outermost hole.
Installation of magnet catch plates.
(1) Remove the top right cover.
(2 screws)
(2) Remove the original guide plate
and platen glass. (2 screws)
(3) Install the magnet catch plates
onto the notches on the control
panel.
(4) Reassemble in reverse order.
Note: Use shoulder screw for the
front side of the original guide
plate.
Installation of ADF
(1) Place ADF on the digital copier.
(2) Slide the sheet feeder forward.
(The screws mentioned above fit
into the holes of both hinges.)
(3) Install the hinge mounting screws
into the front of the hinges and
tighten.
The right side of the ADF (posi-
tion A) and the right side of the
copier (position B) should be
aligned, when the ADF is closed.
2
3
3
A
B