- 4 -
Getting Ready
Installation requirements
Select SIGNAL STRENGTH on the third menu screen and verify the wireless signal
strength. Install the unit in a location where the signal strength is at least -100 dBm. If
you are unable to get a reading of at least -100 dBm, check for obstructions between
the Assembly Qualifier and the tool. However, temporary interference or other issues
may interrupt communications. Be sure to test the Assembly Qualifier adequately at
the site where it is to be used. Using the 4 screw holes, mount the Assembly Qualifier
securely so that it will not fall off the wall. The Assembly Qualifier may cause injury if it
falls from the installation location.
II
.
OPERATION
Quick Start Guide
For more information, refer to the detailed explanation provided for each section
below.
Step 1:
Power up the unit. During power-up the device will load
the program, read stored settings, initialize the radio,
and try to contact a radio tool.
Step 2:
To program a new tool, click the MORE button on the
bottom right corner.
Step 3:
Enter the password (0104 default), or bypass the
password by turning the key to the unlock position
before pressing MORE.
