Panasonic EY75A8, Руководство по эксплуатации

Страница: 12 / 172

- 12 -
EN
6RIW
EY75A7:
0 – 950 rpm
and
0 – 1900 i.p.m.
EY75A8:
0 – 1000 rpm
and
0 – 1900 i.p.m.
• Jobs requiring limited
torque.
• Jobs requiring minimal
GDPDJHRI¿QLVKHG
exterior surface.
* i.p.m. = Impact per minute.
2QO\IRU(<$
6HOIGULOOLQJVFUHZ
0 – 2500 rpm
and
0 – 1200 i.p.m.
• -REVUHTXLULQJÀXVK¿QLVK
of self-drilling screw.
(dia. 4 mm × 15 mm or
smaller)
* i.p.m. = Impact per minute.
Avoid repeatedly depressing the switch
when the bolts and screws are securely
fastened.
Not doing so may cause a delay in rotation
starting, or the Impact Power mode
GLVSOD\WRÀDVKDQGSUHYHQWURWDWLRQIURP
starting for circuit protection.
/('/LJKW
Press the light button and set illumination
condition.
Illuminated
Illuminates by pressing button.
The light turns off when the tool
has not been used for more
than 5 minutes or just after
attaching the battery pack.
Depress the trigger switch and
operate the tool once.
Interlocking trigger
Illuminates while depressing the
trigger switch.
Off
&$87,21
Do not use it as a substitute for a
UHJXODUÀDVKOLJKWVLQFHLWGRHVQRWKDYH
enough brightness.
&$87,21 DO NOT STARE INTO
BEAM.
Use of controls or adjustments or perfor-
mance of procedures other than those
VSHFL¿HGKHUHLQPD\UHVXOWLQKD]DUGRXV
radiation exposure.
Overheat warning
Off
(normal
operation)
Illuminated:
Overheat
(motor)
Flashing:
Overheat
(battery)
Indicates operation has been halted due to
motor or battery overheating.
• If the overheating protection feature
activates, allow the tool to cool thorough-
ly (at least 30 minutes). The tool is ready
for use when the overheat warning lamp
goes out.
• Avoid using the tool in a way that causes
the overheating protection feature to
activate repeatedly.
• The performance of the EY9L42 deterio-
UDWHVVLJQL¿FDQWO\DWDQGEHORZƒ&GXH
to work conditions and other factors.