- 8 -
I. INTENDED USE
These tools can be used to tighten
screws in clutch mode and to drill
holes in wood and metal in drill mode.
Additionally, model EY7950 can be used
to drill holes in soft concrete and similar
materials in hammer mode.
Read the Safety Instructions booklet
and the following before using.
II. ADDITIONAL
SAFETY RULES
1)
Wear ear protectors.
Exposure to noise can cause hearing
loss.
2)
Use auxiliary handle supplied with
the tool.
Loss of control can cause personal
injury.
3)
Hold power tools by insulated
gripping surfaces when perform-
ing an operation where the
cutting tool may contact hidden
wiring;
contact with a “live” wire will
make exposed metal parts of the tool
“live” and shock the operator.
4) Wear a dust mask, if the work causes
dust.
5) Be aware that this tool is always in an
operating condition, since it does not
have to be plugged into an electrical
outlet.
6) When drilling or driving into walls,
floors, etc., “live” electrical wires may
be encountered. DO NOT TOUCH
THE CHUCK OR ANY FRONT
METAL PARTS OF THE TOOL! Hold
the tool only by the plastic handle to
prevent electric shock in case you
drill or drive into a “live” wire.
7) If the bit becomes jammed,
immediately turn the trigger switch
off to prevent an overload, which can
damage the battery pack or motor.
Use reverse motion to loosen
jammed bits.
8) Do NOT operate the Forward/
Reverse lever when the trigger switch
is on. The battery will discharge
rapidly and damage to the unit may
occur.
9) During charging, the charger may
become slightly warm. This is normal.
Do NOT charge the battery for a long
period.
Original instructions: English
Translation of the original instructions:
Other languages
Read “the Safety Instructions” booklet
and the following before using.
EY7442_7450_7950(EU).indb 8
2012-10-16 13:33:03
