background image

Содержание 7671-A

Страница 1: ...UTINE LUBRICATION REQUIREMENTS Lack of or an excessive amount of lubrication will affect the perfor mance and life of this tool Use only recommended lubricants at below time intervals EVERY 8 HOURS OF TOOL OPERATION Fill lubricator reser voir of recommended F R L with spindle oil 29665 If an in line or air line lubricator is not used apply several drops of spindle oil 29665 in air inlet EVERY 40 H...

Страница 2: ...ther disassembly should be done only if it should be necessary to replace a part as Brinelling of the bearing races may occur making replacement necessary To disassemble completely remove bearing 33706 Turn snap ring on spindle so the open portion of the ring will allow the remov al of shaft Remove shaft releasing gear Repeat for removal of opposite shaft and gear ASSEMBLY Assemble snap ring to sp...

Страница 3: ...53 grease or equivalent and coat i d of cylinder with 29665 spindle oil upon assembly Assemble bearings into end plates NOTE Assemble bearing 33709 into end plate with identification markings on the bearing facing out Assemble end plate 33710 with spacer 33701 to rotor and secure with sems fastener 33700 NOTE Torque fas tener to 28 in Ibs Assemble cylinder over rotor aligning air inlet holes in cy...

Страница 4: ...pter 37073 c d guide pin 39768 releasing trigger and spring 32858 To remove oilite casting 33190 l insert screwdriver into mo Assemble oilite casting 33190 l into place in oil cavity fill tor end of housing and unscrew cavity with oil and seal with washer 31389 and screw 30747 40177 PISTOL GRIP HOUSING ASSEMBLY FORWARD DIRECTION OlLlTE CASTING 33190 I WASHER 31369 OIL SCREW 30747 TRIGGER 39764 SPR...

Отзывы: