Panasonic ET-PKR100P, Руководство по установке

Страница: 19 / 22

ENGLISH
- 19
■ If the picture is tilted to the left or right
Adjustable span
Loosen two captive
washer hex head bolts
each at the front and rear.
Range of
adjustment
± 5°
z
Adjust to the position where the picture is not tilted
by loosening the captive washer hex bolts fixing the
projector mounting bracket and the angle adjusting
bracket (two locations in front and rear), and
rotating the projector.
z
Once the picture position has been set, be sure to
retighten the bolts securely.
Attention
z
Do not over-loosen the captive washer hex head
bolts, which are used to secure the adjustable
bracket to the projector mounting bracket.
Otherwise, the projector may fall off.
Attention
z
After checking the position adjustments, check that the screws have been tightened to the torques specified on
page 9.
Note
z
If there is a keystone effect in the image even after adjusting the installation angle in the [POSITION] menu
of the projector without applying keystone correction, the positional relationship between the screen and the
projector is out of alignment. Check that the screen and projector are aligned opposite each other. Alternatively,
perform the keystone correction at the projector.
Specifications
Range of
adjustment
Height (from center of projector
lens to ceiling)
949 mm - 1 429 mm (37-3/8" - 56-1/4")
Horizontal swing angle ±1.2°
Vertical tilt angle ±3°
Horizontal tilt angle ±5°
External dimensions
Width: 344 mm (13-17/32"),
Height: 1 054 mm - 1 534 mm (41-1/2" - 60-13/32"),
Depth: 303 mm (11-15/16")
Weight Approx. 13.5 k g (29.8 lbs.)
Adjusting the installation angle (continued)