Panasonic ET-D75LE95C, Руководство по эксплуатации

Страница: 10 / 30

10-ENGLISH
Lens position setup and focus adjustment (continued)
1) Turn on the projector to start the projection.
2) Press the <
菜单
> button to open the [MAIN
MENU] screen. Then select [PROJECTOR
SETUP] and press the <
执行
> button.
3) Select [SERVICE PASSWORD] in the
[PROJECTOR SETUP] menu and press
the <
执行
> button.
4) In the [SERVICE PASSWORD] entry
screen, enter "7590" using the numeric
buttons on the remote control and then
press the <
执行
> button.
z
The [D75LE90 POSITION] screen appears.
5) Press the <
执行
> button in the [D75LE90
POSITION] screen.
z
[PROGRESS] is displayed on the [D75LE90
POSITION] screen and lens position moves to the
standard position for the ET-D75LE95C.
Note
z
When using the PT-SDZ985C / PT-SDS955C /
PT-SDW935C / PT-SDZ981C, the [MAIN VERSION]
of the projector firmware must be the version
described below. Check the [MAIN VERSION] of the
firmware on the [STATUS] screen and upgrade the
firmware version of the projector as needed.* 1
Projector Main version
PT-SDZ985C / PT-SDS955C /
PT-SDW935C / PT-SDZ981C
4.04 or higher
[STATUS] screen is displayed by selecting [Main
Menu]
→
[PROJECTOR SETUP]
→
[STATUS] or by
pressing the <
状态
> button on the remote control.
菜单
执行
LENS
D75LE90 POSITION
OK
CANCEL
MAIN MENU
PICTURE
POSITION
ADVANCED MENU
DISPLAY LANGUAGE
DISPLAY OPTION
3D SETTINGS
PROJECTOR SETUP
TEST PATTERN
P IN P
4.02
SDZ985C
LAST USED
SW1234567
ET-LAD120
2/2
PROJECTOR SETUP
STARTUP INPUT SELECT
RS-232C
STATUS
SAVE ALL USER DATA
LOAD ALL USER DATA
INITIALIZE
SERVICE PASSWORD
*1: See software download page on website (https://panasonic.net/cns/projector/pass/).
You must be a registered PASS user to use the site described above.
PASS : Panasonic Professional Display and Projector Technical Support Website
Note
z
The lens position set here may not match the intended standard position exactly.
z
The lens position set with this procedure will be used as the standard position. The lens
position can be adjusted within the adjustment range described in "Adjustment range by the
lens position shift (optical shift)" (  Page 12), even after shifting to the standard position.
z
Depending on the (OSD) display position on the menu screen, there are cases where the
projected light is obstructed and a part of the menu is not displayed on the screen. In this
case, open [MAIN MENU]
→
[DISPLAY OPTIONS]
→
[ON-SCREEN DISPLAY]
→
[OSD
POSITION] and change settings so that the whole OSD menu can be seen.
z
When using PT-SDZ985C / PT-SDS955C / PT-SDW935C / PT-SDZ981C