12
Reading lamps when using
While using
Approximate amount of battery capacity is
displayed as 20 ‑ 100.
•
It will turn off approximately 5 seconds after
operating the power switch.
•
The shaving sensor lamp ( ) glows.
When the battery capacity is low
“20” blinks when operating the shaver.
•
You can shave 2 to 3 times after “20” blinks. (This will differ
depending on usage.)
•
The shaver can be used for approximately 2 weeks with a full
charge.
(Based on one 3‑minute dry‑shave use per day until the battery
is exhausted)
•
The number of usable days varies depending on the following
conditions.
-
Beard thickness
-
Pressure applied to the skin
-
Ambient temperature
-
Usage frequency of the sonic vibration cleaning mode
Cleaning the shaver
Cleaning using the self-cleaning recharger
The self‑cleaning recharger cleans the inner blades and the
system outer foil. Brush or wash with water to remove beard
trimmings in other areas.
►
Preparing the self-cleaning recharger
Remove the AC adaptor from the self‑cleaning recharger.
1
1
Place the self-cleaning recharger on a hard, flat
surface.
•
If the self‑cleaning recharger sits at an angle, liquid may
spill or the number of days that cleaning liquid can be used
may reduce.
•
When the self‑cleaning recharger is lifted, or on the soft
surface such as carpets, the lock release lever will not fit in
the recharger properly. In that case, the cleaning liquid unit
cannot be removed.
2
2
Press the cleaning
liquid unit removal
button (
1
) and
remove the
cleaning liquid unit
(
2
).
3
3
Wash away the old cleaning liquid and beard
trimmings and then rinse the cleaning liquid unit.
(See page 16.)
•
After washing, be sure to attach the cleaning liquid filter.
ES-LT8N_AUS(EN).indd 12
2015/05/13 20:04:32
