17
3. Gently wipe off any beard trimmings attached
to the inside of the cleaning tray (
a
) with a
cloth or tissue paper dampened with water.
•
Clean the corners and uneven parts of the
cleaning tray with a cotton swab dampened
with water.
►
When the water does not drain from the cleaning tray
•
Do not tilt the self‑cleaning recharger to pour out water. Doing so
may cause the cleaning liquid in the cleaning liquid unit to spill or
cause the self‑cleaning recharger to malfunction.
•
Beard trimmings may clog the drain at the
bottom of the cleaning tray.
In this case, you cannot clean or dry the shaver.
1. Be sure to remove the AC adaptor from the
self‑cleaning recharger.
2. Place the self‑cleaning recharger on a flat
surface, and push the beard trimmings down
through the drain (
b
) with a toothpick etc.
Troubleshooting
Perform the following actions.
If the problems still cannot be solved, contact the store where
you purchased the unit or a service center authorized by
Panasonic for repair.
►
Self-cleaning recharger
Problem
Action
The blade has not been
thoroughly washed.
If the shaver is not cleaned for
more than 2 weeks, first clean
with the cleaning brush to remove
beard trimmings. (See page 15.)
Do not add detergent and water
except when replacing the
cleaning liquid.
Doing so may deteriorate the
cleaning function. (See page 13.)
After cleaning, oil‑like droplets
may remain on the outside of the
foil frame. This is the lubricating
component of the cleaning liquid
and does not indicate a problem.
You may wipe it off with a soft
cloth.
The STATUS lamp glows.
See page 21.
ES-LT8N_AUS(EN).indd 17
2015/05/13 20:04:33
