13
English
The battery replacing service is available only in the United States
of America.
Disconnect the power cord from the shaver when removing the
battery.
Perform steps
1
to
4
and lift the battery, and then remove it.
Specifications
Power source
See the name plate on the AC adaptor.
(Automatic voltage conversion)
Motor voltage
3.6 V
Charging time
Approx. 1 hour
This product is intended for household use only.
•
•
FORYOURCONVENIENCE,WEHAVEESTABLISHEDA
TOLL‑FREE(INUSAONLY)NATIONALACCESSORY
PURCHASEHOTLINEAT1‑800‑332‑5368.
INCANADA,CONTACTPANASONICCANADAINC.ATTHE
ADDRESSORTELEPHONENUMBERONTHEBACKPAGE.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to
correct the interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for
help.
FCC Caution: To assure continued compliance, install and use in
accordance with provided instructions. Any changes or
modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate this
equipment.
•
•
•
•
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and () this device must accept any
interference received, including interference that may cause
undesired operation.
