9
Engli
sh
Preparation
Charging
•
Make sure that the main body is turned off.
1
Connect the appliance plug
to the appliance socket.
2
Plug in the adaptor into a
household outlet.
•
Check that the charge status
lamp ( ) glows.
•
Charging is completed after
approx. 1 hour.
1
2
3
Disconnect the adaptor when the charge status
lamp stops glowing.
(for safety and to reduce energy usage)
<How to check if the charging is completed>
Remove and reinsert the appliance plug. If the
charge status lamp glows and turns off after
approximately 5 seconds, it is completed.
Notes
•
To keep charging the battery will not affect battery
performance.
•
If there is noise from the radio or other sources while
using or charging the appliance, move to a different
location to use the appliance.
•
When the appliance is not used for 6 months or more,
the battery will weaken (leak battery fluid, etc.). Fully
charge the battery once every 6 months.
• When the appliance is charged for the first time or it
has not been in use for more than 6 months, the
charging time may change or the charge status lamp
may not glow in the first few minutes. In addition, the
operating time may become shorter. Please charge it
for more than 8 hours in such cases.
•
Recommended ambient temperature for charging
is 0 °C – 35 °C. The charging time may change or
battery performance may decrease outside of the
recommended temperature.
•
A full charge supplies enough power for approximately
50 minutes of use. (Based on using at 20 °C – 30 °C.)
The operating time may differ depending on the
frequency of use and the operating method.
•
You can charge the battery before it is completely
discharged. However, it is recommended to charge
when the battery is completely discharged. The
battery life depends strongly on factors such as how it
is used and stored.
AC operation
If you connect the AC adaptor to the appliance in the
same way as for charging, and turn on the power, you
can use it.
•
The battery will be discharged, even with the AC operation.
•
If the remaining battery is too low, the blades may
move slowly or stop, even with the AC operation. In
this case, charge the battery for 1 minute or more.
PB017539 - ER-GD30 20������_(01GB)_04-04-19.indd 9
2019/4/4 10:52:40
Содержание ER-GD20
Страница 2: ...2 PB017539 ER GD30 20 _ 01GB _04 04 19 indd 2 2019 4 4 10 52 29 ...
Страница 17: ...17 MEMO PB017539 ER GD30 20 _ 01GB _04 04 19 indd 17 2019 4 4 10 52 46 ...
Страница 18: ...18 MEMO PB017539 ER GD30 20 _ 01GB _04 04 19 indd 18 2019 4 4 10 52 46 ...
Страница 31: ...31 PB017539 ER GD30 20 _ 02AR _04 08 19 indd 31 2019 4 8 10 33 50 ...
