Panasonic EP-MA82, Руководство по эксплуатации

Страница: 60 / 104

EN10
Setting up the massage lounger
Hold onto the sides
Groove
Legrest Back cover Mat
Do not hold onto the
front side.
The sole massage
section might slide,
and injuries may
occur.
Hold onto
the sides of
the legrest.
Place your
fingers in
the groove.
Ensure there is adequate space to recline.
● Dimensions required for installation ( see page EN51 for the detailed dimensions of the main unit)
Height 115 cm × Width 100 cm × Depth* 226 cm
* The main unit is approx. 206 cm in length, and it is necessary to keep it more than 10 cm from obstacles such as walls,
so a length of 226 cm should be reserved.
● Do not expose the massage lounger to direct sunlight or high temperatures.
This can cause discoloration or hardening of the synthetic leather.
Move the unit by holding on the groove on the back cover
of the backrest.
(Groove position inside the back cover leather, need to lift
the back cover of leather.)
Accessories
● Power cord
●
Pillow
●
Set screw
● Smart storage
● Controller stand
● Hex wrench
● Lock switch key
● Comfort cushion
This is initially inserted
in the lock switch of the
power switch section prior
to leaving the factory.
Controller holder
fixing screw
Controller
holder
(four)
● Since the unit is very heavy, be careful to avoid
back injuries. (The unit must be carried by two
or more persons.)
Product weight Approx. 108 k g
To put the unit down on the floor
●
Put the unit down slowly watching your step
carefully.
● Put down the legrest by holding it with your
hands until it has been set on the floor
completely. If you release your hands before
the legrest is fully extended, the legrest will
forcefully return to the initial position.
● It is suggested to pave an article such as a mat
on the floor to keep it from damage.
1
Confirm that the main unit and the accessories are in
the box
2
Where to use the unit
3
To set up