EBL512 G3 V. 3.0.X
- FIRE ALARM SOLUTIONS OPERATING INSTRUCTIONS
102
30.8. INFORMATION (H4/U8)
This menu can be used to show the following information for the specific control unit you currently use:
Main board version
: The S/W (software / firmware / system program) version downloaded to the Main board.
MMI board version
: The S/W (software / firmware / system program) version downloaded to the MMI board.
Alarm counter
: The alarm counter is increased with "1" every time the c.i.e. enters a real "fire alarm condition" (i.e. fire alarm
indication in the display, LEDs "Fire" are lit and the c.i.e. buzzer is sounding). Alarms from zones in test mode will not be counted.
It starts on 000 and goes to 999. It can be reset to 000 via EBLWin (Control unit menu "Reset alarm counter…"). The value will be
retained also after the c.i.e. has been completely powerless. During synchronization, the alarm counter will also be synchronized, so
that the highest value is stored in each control unit in the system.
Max. number of allowed alarm points: that can be used in this control unit, i.e. 128, 256 or 512. (Configured number of alarm points.)
Serial number: The manufacturer's serial number (year YY, week WW, plant P, number of the main board NNN). Used e.g. when
upgrading max. no. of allowed alarm points. Control unit number: 00-29.
a) Log on to the c.i.e.
b) Navigate to menu U8.
c) To exit the menu press ESC
.
Main board version: 3.0.0
MMI board version: 3.0.0
Alarm counter: nnn
Max number of allowed alarm points: xxx
Serial number: xxxxxxxx
Control unit: NN