11
VQT2H73
G
etti
n
g
s
ta
rte
d
2
Adjust the LCD screen.
Rotate the monitor backwards so the screen is facing out.
(
>
10)
3
Attach the unit to the bracket.
1
While holding the unit with both hands, line up the unit just
below the protruding sections (
A
) on the bracket.
2
Press the unit down about 4 to 5 mm so that the
protrusions on the bracket fit into the holes on the bottom of
the unit.
≥
When correctly attached, you will hear a locking sound.
3
Fasten this unit by tightening the screw at the bottom of the
bracket.
4
Adjust the belt until it fits tightly around the headrest.
≥
Please check the following points before use.
j
The bracket is securely fastened to the unit.
j
The unit is not loose and cannot be lifted upwards.
≥
Depending on the type of headrest, you may not be able to
attach the bracket.
∫
Detach the unit from the bracket.
1
Loosen the screw at the bottom of the bracket.
2
Press the release buttons (left and right) in towards the
centre of the bracket.
3
Lift the unit up to release it.
≥
Do not press the release buttons any time other than
when detaching the unit from the bracket.
click!
30°
Use the LCD screen in the open
position as shown in the
illustration below to prevent
abnormal audio or damage
resulting from vibrations in the
car.
The angle of the LCD screen can
be adjusted up to about 30
o
.
Diagram of the
attached bracket and
unit
≥
The angle
of the LCD
screen may
shift while
driving due
to vibration,
etc.
23 cm or less
In the event of an accident etc., the
unit could become loose and cause
injury.
DO DO
NOT
Release button
VQT2H73~Body1_mst.fm 11 ページ ２０１０年１月２２日 金曜日 午前９時３８分
