Panasonic DMC-FT25EB, Руководство по обслуживанию, Страница: 54 / 92

■ IMPORTANT NOTICE (After replacing the MAIN P.C.B.)
After replacing the MAIN P.C.B., make sure to perform the "INITIAL SETTINGS" first, then release the "INITIAL SETTINGS" in order to proceed the electrical adjustment.
Note:
1. If electrical adjustment or data re-writing is executed before "INITIAL SETTINGS", suffix code list is never displayed, and it cannot be chosen suitable suffix
code.
2. Never remove the battery during initial setting in process.
10.4 After Adjustment
10.4.1 Initial Setting
Since the initial setting has been released to execute the built-in adjustment software, it should be set up again before shipping the camera to the customer.
Refer to the procedure described in "3.6.2.
INITIAL SETTINGS " for details.
[IMPORTANT]
1. The initial setting should be done again after completing the alignment. Otherwise, the camera will not work properly.
Therefore as a warning, the camera display a warning symbol " ! " on the LCD monitor every time the camera is turned off.
2. Confirm that status of all adjustment flag show "F". Even if one of the adjustment flag shows "0", initial setting programmed is never executed.
3. Adjustment software "DIAS" is able to control the status of the adjustment flags.
The Adjustment software "DIAS" is available at "TSN Website", therefore, access to "TSN Website" at "Support Information from NWBG/VDBG-AVC".
Page 6 of 6
10/28/2017 file://\\royalfs\Service\Technical\Ms.dehghani\All SVC sent by CD\20\DMC-FT25EBAL...