Others
- 186 -
•
Is the mode dial correctly set?
•
Is there any memory remaining on the built-in memory or the card?
>
Delete the pictures which are not necessary to increase the available memory.
(P58)
•
The picture can become whitish if there is dirt e.g. fingerprints on the lens.
>
When it is dirty, lightly wipe the surface of the lens with soft and dry cloth.
•
Was this picture taken with the flash at the close range when the zoom is near [W] (1
k
)?
>
Zoom in a little, and then take the pictures.
(P52)
>
Is this a picture taken in [PIN HOLE] in Scene Mode?
>
Check that the exposure is correctly compensated.
(P70)
•
Setting the [MIN. SHTR SPEED] to faster speed might make the picture darker.
>
Set the [MIN. SHTR SPEED]
(P116)
to slower speed.
>
Set Auto Bracket
(P71)
, [HI-SPEED BURST]
(P82)
, [FLASH BURST]
(P83)
in Scene Mode
or [BURST]
(P117)
of the [REC] Mode menu to [OFF].
•
The focus range varies depending on the recording mode.
>
Set to the proper mode for the distance to the subject.
•
The subject is beyond the focus range of the camera.
(P49)
•
There is camera shake (jitter) or the subject is moving slightly.
(P51)
•
Turn the power on again. If the operations are still not working normally, remove the power and
consult the dealer or your nearest service centre.
>
The shutter speed becomes slower when pictures are taken in dark places so hold the
camera firmly with both hands to take the pictures.
(P43)
>
When taking pictures at a slow shutter speed, use the self-timer.
(P69)
Recording
The picture cannot be recorded.
The recorded picture is whitish.
The area around where the pictures were taken becomes dark.
The recorded picture is too bright or dark.
2 or 3 pictures are taken at one time.
The subject is not focused properly.
The auto-focus and other operations are not working normally.
The recorded picture is blurred.
The Optical Image Stabilizer is not effective.
DMC-FT2PDF_EB.book 186 ページ 2010年2月1日 月曜日 午後6時8分