11
Commis
sioning
Press
The nozzle retracts.
Press
Remove the plastic film.
Once the nozzle retracts, water for nozzle self-cleaning will come out.
Press and to set the temperature. After 5 -12 minutes, sit at the seat to check the seat
and water temperature.
It takes approximately 5 - 12 minutes for the temperature of the seat and warm water to stabilize.
(Depending on ambient temperature and the temperature of tap water.)
Press and hold the rear left portion of the seat. (The Occupancy indicator is on.) Meanwhile,
press or
Deodorization starts. (with motor sound)
The nozzle starts self-cleaning. After approximately 5 - 8 seconds, cleaning water will be sprayed.
(If the Occupancy Switch is not enabled, no water will be sprayed.)
Check if cleaning water is sprayed normally with the plastic film.
7
8
9
10
3
7
8
9
11
6
12
Press and hold the rear left portion of the seat.(The Occupancy indicator is on.) Meanwhile,
Press , confirm warm air function , then press .
11
After showering stops, droplets will fall from around the nozzle. These are the water resulted from thermal expansion
of the warm water tank or water remaining in the nozzle. This is not a malfunction. (Approximately 7 - 8 minutes after
showering)
The back mount of the seat and the front leg are floating It is normal.
If this gap is not present, seating detection will not be detected.
The Occupancy Switch is enabled when the seat is occupied
Occupancy indicator
Water release outlet
There is a gap
About releasing water
The water flowing out next to the nozzle (water release
outlet) is the one released for pressure adjustment.
This is not a malfunction.
If the water release outlet is placed on the surface
of the toilet, water may not flow into the toilet. At
this time, install the body sightly forward. [Page 7]
