63
RQT8850
Ref
erence
Error Messages
On the Unit’s Display
Page
H , F
(“ ” stands for a service
number.)
An error has occurred. The number following “H” or “F” depends
on the status of the unit. Check the items below and in the
Troubleshooting Guide. If the service number still does not disappear
after the check, reset the unit (
➔
55, “To restore the unit if it freezes” ).
•
−
If the service numbers fail to clear, note the service numbers and
contact a qualified service person.
•
−
RC (“ ” stands for a
number.)
The remote control and main unit are using different codes. Change
the code on the remote control.
•
55
HARD ERR
(“HArd” and “Err” are
alternately displayed.)
If there is no change after turning the unit on and off, consult the
dealer where the unit was purchased.
•
−
NO READ
(“NO” and “REAd” are
alternately displayed.)
The disc is dirty or badly scratched. The unit cannot record, play, or
edit.
•
53
The disc may be incompatible or of poor quality.
•
53
You have used a lens cleaner and it has finished operation. Press
[
;
OPEN/CLOSE] on the main unit to eject the disc.
•
3
Displayed when the unit is started. This is not a malfunction.
•
−
The unit is carrying out its recovery process. You cannot operate the
unit while “ ” is displayed.
•
−
FULL
There are already 16 scheduled recording programs. Delete
unnecessary scheduled recording programs.
•
15
UNSUPPORT
(“UNSUP” and “POrt” are
alternately displayed.)
You have inserted a disc the unit cannot play or record on.
•
53
UNFORMAT
(“UNFOr” and “MAt” are
alternately displayed.)
You have inserted a new DVD-RW/+RW or a DVD-RAM/DVD-RW
(DVD-Video format) recorded on other equipment.
You can format the disc when the format confirmation screen is
displayed.
•
28
U59
The unit is very warm.
The unit switches to standby for safety reasons. Wait for about 30
minutes until the message disappears.
Reinstall the unit in an area with adequate ventilation. Do not block
the cooling fan on the rear of the unit.
•
−
U61
There was a power failure or the AC power supply cord was
disconnected while the unit was on. The unit is carrying out its
recovery process. This process restores the unit to normal operation.
The unit is not broken. Wait until the message disappears.
•
−
U88
There was something unusual detected with the disc while recording,
playing; there was a power failure or the AC power supply cord
was disconnected while the unit was on. The unit is carrying out its
recovery process. This process restores the unit to normal operation.
The unit is not broken. Wait until the message disappears.
•
57
U99
The unit fails to operate properly. Press [POWER
^
/I] on the main
unit to switch the unit to standby. Press [POWER
^
/I] on the main unit
again to turn the unit on.
•
−
RQT8850-P.indb 63
RQT8850-P.indb 63
2007/01/26 13:22:03
2007/01/26 13:22:03