Drain hose
Connecting cable
Adjust the piping slightly downwards.
Oxygen Tube
Piping
Drain
hose
Sleeve for
piping hole
Connecting cable
More than approx. 95 cm
Installthe IndoorUnit
Hook the indoor unit onto the
upper portion of installation plate
(Engage the indoor unit with the
upper edge of the installation
plate). Ensure the hooks are
properly seated on the installation
plate by moving in left and right.
Hooks at
installation
plate
Sleeve for
piping hole
Piping
Drain hose
Indoor unit
Installation
plate
hook
Unit's
Secure the IndoorUnit
1. Tape the extra power supply cord in a
bundle and keep it behind the chassis.
Ensure that the power supply cord is
not clamped in between the unit's hook
(2 positions) and installation plate.
2. Press the lower left and right side of the
unit against the installation plate until
hooks engages with their slots
(sound click).
Insert the connecting cable
Length of
connecting cable
77 cm
Cable
Gas side piping
Connecting
cable
Drain hose
Guide surface
Connecting cable
Gas side piping
About
7
- 8 cm
Liquid side piping
Liquid side piping
Oxygen tube
Pull out the piping and drain hose
Move the drain hose
near to arrow mark and
tape it with piping in
a position as mentioned
in Fig. below
Drain hose
Piping
Cover for
the right piping
Cover for the bottom piping
Cover for the bottom piping
Cover for the left piping
: Centre of the piping hole
(left rear side of piping)
CS-XA9DKD/ CU-XA9DKD/ CS-XA12DKD/ CU-XA12DKD