10
TROUBLESHOOTING
The following symptoms do not indicate malfunction.
The following symptoms do not indicate malfunction.
SYMPTOM
SYMPTOM
CAUSE
CAUSE
Mist emerges from indoor unit.
►
• Condensation effect due to cooling process.
Water
fl
owing sound during operation.
►
• Refrigerant
fl
ow inside the unit.
The room has a peculiar odour.
►
• This may be due to damp smell emitted by the wall,
carpet, furniture or clothing.
Indoor fan stops occasionally during automatic fan speed
setting.
►
• This helps to remove the surrounding odours.
Air
fl
ow continues even after operation has stopped.
►
• Extraction of remaining heat from the indoor unit
(maximum 30 seconds).
Operation is delayed a few minutes after restart.
►
• The delay is a protection to the unit’s compressor.
Outdoor unit emits water/steam.
►
• Condensation or evaporation occurs on pipes.
Timer indicator is always on.
►
• The timer setting repeats daily once set.
Power indicator blinks during HEAT mode with no warm air
supply (and louver is closed).
►
• The unit is in defrost mode (and AIR SWING is set to
AUTO).
Indoor fan stops occasionally during heating operation.
►
• To avoid unintended cooling effect.
Power indicator blinks before the unit is switched on.
►
• This is a preliminary step in preparation for the operation
when the ON timer has been set.
Cracking sound during operation.
►
• Changes of temperature cause the expansion/contraction
of the unit.
2 or more human activity indicator turns on simultaneously.
►
• Judgement of heat source and movement area in
progress.
Check the following before calling for servicing.
Check the following before calling for servicing.
SYMPTOM
SYMPTOM
CHECK
CHECK
Heating/Cooling operation is not working ef
fi
ciently.
►
• Set the temperature correctly.
• Close all doors and windows.
• Clean or replace the
fi
lters.
• Clear any obstruction at the air inlet and air outlet vents.
Noisy during operation.
►
• Check if the unit has been installed at an incline.
• Close the front panel properly.
Remote control does not work.
(Display is dim or transmission signal is weak.)
►
• Insert the batteries correctly.
• Replace weak batteries.
The unit does not work.
►
• Check if the circuit breaker is tripped.
• Check if timers have been set.
The unit does not receive the signal from the remote
control.
►
• Make sure the receiver not obstructed.
• Certain
fl
uorescent lights may interfere with signal
transmitter. Please consult authorized dealer.
Patrol sensor or e-ion indicator on the indoor unit is
blinking.
►
• Stop Patrol or e-ion operation then restart. If the patrol
sensor or e-ion indicator still blinking, please consult
authorized dealer.
