1
2
3
4
No.
1
17
CQ-FX323W
1
E
N
G
L
I
S
H
16
11
E
N
G
L
I
S
H
CQ-FX323W
Q’ty
Diagram
Item
Supplied Hardware
Fire Wall of the Car
t
Hex. Nut
r
Rear Support Strap
w
Mounting Bolt
q
Mounting Collar
e
Tapping Screw
3 mmø
(a) Using the Rear Support Strap
Rubber Cushion
(Option)
w
Mounting Bolt
q
Mounting Collar
Rear Support Bracket
(Provided on the car)
(b) Using the Rubber Cushion (Option)
Mounting Tabs
Mounting Bolt
w
Insert Trim Plate
u
.
After installation reconnect the
negative (–) battery terminal.
Insert Mounting Collar
q
into the
dashboard, and bend the mounting
tabs out with a screwdriver.
q
w
e
r
t
y
Mounting Collar
Mounting Bolt (5 mmø)
Tapping Screw
(5 mmø x 16 mm)
Rear Support Strap
Hex. Nut (5 mmø)
Power Connector
1
1
1
1
1
u
Trim Plate
1
12
Caution:
Do not disconnect the battery terminals of a car
with trip or navigational computer since all user settings
stored in memory will be lost. Instead take extra care with
installing the unit to prevent shorts.
Installation
Preparation
CQ-FX323W
¡
Before installation, check the radio operation with antenna
and speakers.
¡
Disconnect the cable from the negative (–) battery terminal
(see caution below).
¡
Unit should be installed in a horizontal position with the front
end up at a convenient angle, but not more than 30°.
Dashboard Installation
Installation Opening
The unit can be installed in
any dashboard having an
opening as shown at right.
The dashboard should be
4.5 mm - 6 mm thick in order to be able to support the unit.
Installation Precautions
This product should be installed by a professional installer, if
possible.
In case of difficulty, please consult your shop when you pur-
chased this unit.
1. This system is to be used only in a 12-volt, DC battery sys-
tem (car) with negative ground.
2. Follow the electrical connections carefully (
a
Page 20).
Failure to do so may result in damage to the unit.
3. Connect the power lead (red) after all other connections are
made.
4. Be sure to connect the battery lead (yellow) to the positive
terminal (+) of the battery or fuse block (BAT) terminal.
5. Insulate all exposed wires to prevent short circuiting.
6. Secure all loose wires after installing the unit.
7. Please carefully read the operating and installation instruc-
tions of the respective equipment before connecting it to this
unit.
182 mm
53 mm
First complete the electrical connections, and
then check them for correctness.(
a
Page 20)
The included Mounting Collar
q
q
is
designed specially for this unit .
Do not use it to attach any other models.
Power Connector
y
Cautions:
¡
We strongly recommend that you wear gloves for installation work to protect yourself from injuries.
¡
When bending the mounting tab of the mounting collar with a screwdriver, be careful not to injure your hands and
fingers.
30° or less
Establish the rear connections of the
unit.
After fixing Mounting Bolt
w
and Power
Connector
y
, Establish the rear connections of
the unit to the car body by either method (a) or (b)
shown on the previous page.
Make sure that the lock lever
(
C
) is flush with the mounting
collar (not projecting outward).
Lock Lever
Lock Lever (
C
)
