Panasonic AWPH405N - PAN/TILT CAMERA, Руководство по эксплуатации

Страница: 24 / 72

24
Installation
(Be sure to ask your dealer to install the unit.)
w
Mounting the camera
[Multi Purpose Camera (AK-HC1500G/AK-HC1800G)]
When mounting the camera, take sufficient care to ensure that the camera will not come off or fall down.
Mount the lens onto the multi purpose camera.
(1) Lenses that can be used
• Use any of the portable lenses which are listed below.
Fujinon HA18, HA21, HA22 series
Canon HJ17e, HJ21e series
Notes
p
Use the lens fixing ring knob to tighten
the lens securely, and check for play.
Check the hood for play as well.
p
The current rating of LENS I/F (2)
connector is 500 mA (max).
Even with the lenses in a series which
can be used, any lens whose maximum
current consumption exceeds 500 mA
cannot be used.
Concerning the maximum current
consumption of the lens, contact the lens
manufacturer.
(2) Lenses that cannot be used
• Do not use the large-sized lenses [with a mass (weight) of 5 kg (11 lbs) or
more and a length of 400 mm (15-3/4˝ ) or more] with the model numbers
which are listed below since when they are mounted on the camera, the
camera’s overall balance will be upset.
Fujinon HA42 series
Canon HJ40 series, J35 series
Align the multi purpose camera with the guide pins and mount it.
Change the positions of the guide pins and screws of the camera mounting base as shown in the figure below, and then
attach the camera mounting base to the rotary arm.
p
Tighten up the 2 mounting screws securely using the
flathead screwdriver.
Lens fixing ring knob
Set the guide pin.
Mount the camera
with the mounting
screws.
Mounting screws
For a stand-alone installation
Camera mounting base
Change the positions
of the guide pins.
Change the positions of the camera mounting
screws. (Change them over to the second row.)
Mount the camera with
the mounting screws.
Set the guide pin.
Mounting screws
For installation on the ceiling
Camera mounting base
Change the positions
of the guide pins.
Change the positions of the camera mounting
screws. (Change them over to the third row.)
p
Just as for a convertible camera, change the positions of
the guide pins and screws of the camera mounting base
as shown in the figure above, and then attach the camera
mounting base to the rotary arm.
Attaching the guide pins
and camera
Clamping torque
Guide pins (M4) 1.5 N
•
m (15 kgf
•
cm)
Mounting screws (Inch thread) 2.0 N
•
m (20 kgf
•
cm)