- 24 -
Connections
5
1394 connector
This is for controlling the convertible
camera, in which an IEEE 1394 card
has been installed, and the pan/tilt head.
As the connecting cable, use an IEEE
1394 cable.
<Note>
O
This unit cannot be controlled directly
using an IEEE1394 card. A convertible
camera containing the plugged-in
IEEE1394 card is needed.
6
CONTROL IN IP/RP connector
This is for camera/pan/tilt head control
signals.
Connect this to the PAN/TILT
CONTROL OUT connector on the
controllers AW-RP301/AW-RP305/
AW-RP501/AW-RP505, or multiport hub
AW-HB505, CONTROL OUT TO
PAN/TILT HEAD connector on the
controller AW-RP605A, or CONTROL
OUT TO PAN/TILT connector on the
controller AW-RP400.
Use a 10BASE-T straight cable (UTP
category 5) for the connecting cable.
<Notes>
O
Depending on the controller to be used,
it may be necessary to change the
switch positions. For details on how to
do this, refer to the section on “Controller
selection switch settings” under
“Installation” (page 10).
O
For your safety, connect to an Ethernet
network which does not exceed the
voltage limit of the Ethernet connector.
7
Y OUT connector
This is for camera video signal output.
Connect this to the Y IN connector on
the controller or to a monitor, etc.
Use a coaxial cable (BELDEN 8281) for
the connecting cable.
8
Pr/SDI OUT connector
This is for camera video signal output.
Connect this to the Pr IN connector on
the controller or to a monitor, etc.
SDI signals can be output when an SDI
card (AW-PB504N, etc.) is installed in
the convertible camera for use.
Use a coaxial cable (BELDEN 8281) for
the connecting cable.
<Note>
O
To switch from Pr to SDI or vice versa, it
is necessary to change the switch
positions. For details on how to do this,
refer to the section on “Transmission
signal selection setting” under
“Installation” (page 11).
$
Connecting the base connector rear panel and the base
connector front panel
Pin No.
Signal
1
DC 12V
2
GND
3
TPB
2
4
TPB
5
TPA
2
6
TPA
