- 13 -
Installation
(The installation work must be performed by your dealer without fail.)
Safety wire
$
Installing the pan/tilt head
Be absolutely sure to follow the instructions below when installing the pan/tilt head. Failure
to do so may cause the pan/tilt head to slip out of position or fall.
O
For wall
Do not install the pan/tilt head on any of its sides.
The wall should be capable of supporting a weight of at least four times the pan/tilt head
with camera etc. weight 59.5 lb (27 kg).
O
Make sure that the installation of the pan/tilt head has been completed before mounting
the camera onto it.
O
To mount the pan/tilt head, use the four mounting holes and secure it firmly in place.
O
Have M6 hexagonal bolts ready as these must be used for mounting the pan/tilt head.
O
The hexagonal bolts must be long enough to meet the requirement of “mounting material
thickness plus 25 mm or longer”.
O
Use flat washers, spring washers and hexagonal nuts with the hexagonal bolts, as
shown in the figure.
O
Use a wrench that fits the size of hexagonal bolt heads to tighten the hexagonal bolts.
O
For suspended installation, pass a wire through the safety wire mounting hole, and
fasten it securely to the ceiling or other structurally sound object.
O
Have a wire ready which is strong enough to bear the weight of the entire pan/tilt head
system (pan/tilt head, camera, lens and cable).
O
Install the pan/tilt head so as to ensure that none of the components mounted on the
pan/tilt head or cables will come into contact with any objects in the vicinity when the
pan/tilt head rotates.
<Note>
When installing the pan/tilt head, refrain from forcibly turning the head or tilting arm by
hand. Doing so may cause the unit to malfunction.
