Panasonic AW-HE38HWP, Руководство по эксплуатации

Страница: 125 / 140

125
Troubleshooting
●
Operation
Symptom Cause and remedial action
Reference
pages
No power
●
Is the AC adaptor securely connected to the AC outlet?
–––
●
If the power plug of the AC adaptor connected properly?
–––
●
Is the network cable for the PoE+ (IEEE802.3at) compatible power
supply device and the unit connected properly?
<Basics>
P.35
●
Power may not be supplied if the total power limit is exceeded on
power supply devices that allow connections to multiple PoE+
terminals.
 Refer to the operating instructions for the PoE+ power supply device.
<Basics>
P.35
The status display
lamp flashes red
continuously
●
The PoE+ power supply conditions do not meet the specifications.
 Check the power supply device.
<Basics>
P.35
The status display lamp
flashes red several
times
●
An error such as an attempt to perform a recording operation while
an SD card is not inserted has occurred.
 Check the event log.
P.105
Cannot operate
(common to wireless
remote control,
controller)
●
Is the power on?
 If the unit’s status display lamp is off or if it has lit up orange,
it means that the unit’s power is not being supplied.
P.7
●
Have the limiter functions been set?
P.121 to 122
●
Has the correct unit to be operated been selected?
P.9
Cannot operate using
the wireless remote
control
●
Have the remote control’s batteries run down or have the batteries
been installed with their polarities reversed?
 If the status display lamp does not blink even when the wireless
remote control is operated near the wireless remote control signal
light-sensing area, it means that the batteries have run down.
Replace the batteries.
–––
●
Has the IR ID setting been set correctly? P.48, P.85
●
Is there a fluorescent light or plasma monitor near the unit and, if
so, is the wireless remote control signal light-sensing area exposed
to its light?
<Basics>
P.39
Cannot operate using
the controller
●
Is the unit connected to the controller properly?
 Refer to the Operating Instructions of the controller.
<Basics>
P.19 to 24
●
The user authorization must be set to OFF when the AW-RP50,
AW-RP120, and AK-HRP200 remote camera controllers are
connected in a network.
P.88
●
Are all the cameras in the daisy-chain connection turned on?
<Basics>
P.20
●
It may be necessary to upgrade the version of the controller so that
the controller will support the unit. <Basics>
P.36