![background image](http://html1.mh-extra.com/html/panasonic/ak-hrp200gj/ak-hrp200gj_operating-instructions-manual_3517322008.webp)
8
9
Precautions for installation
Observe the following in addition to the information included in “Read this first!”.
Have your supplier install the unit and handle connections.
Cable connections
• Be sure to use dedicated remote operation panel (ROP) cables.
• If the unit will not be used for an extended period of time, disconnect
the ROP cables to save electricity.
Handle carefully
• Make sure you do not drop or expose the unit to strong impacts or
vibrations that could damage the product or cause accidents.
Do not insert foreign material in the unit.
• Foreign materials such as water, metal objects, food or drink that
enter the unit could cause a fire or electrical shock.
Installation location
• This unit is designed for indoor use.
• Use the unit on a stable and horizontal surface that is sufficiently
capable of supporting its weight.
• When the unit will be recessed into a panel or table, make sure that
enough space is provided for ventilation and cables.
• Do not install the unit in a location where it and the cables can be
easily damaged.
• Do not install the unit in a location where the temperature drops to
0°C (32°F) or lower or reaches 40°C (104°F) or higher.
• Do not install the unit in a location exposed to direct sunlight or near
exhaust vents that expel hot air.
• Do not install the unit in a location exposed to excessive humidity,
dust or vibrations to prevent malfunction.
Setting up the unit
Installing and removing rack mount brackets
Rack mount bracket
Rack mount bracket
Securing screws
Securing screws
The unit is shipped from the factory with the rack mount brackets
installed.
The customer can remove the four screws that hold the rack mount
brackets in place using a Phillips screwdriver.
<Note>
• After detaching, store the rack mount brackets and the screws in a
location easily accessible when required.
• Next time you use the rack mount brackets to secure the unit, tighten
the four screws to a torque of 50 N•cm or more.
Rack installation (rack mounting)
Securing screw (commercially available)
Secure the unit to the rack using two screws.
<Note>
• The securing screws are not supplied with the unit. Purchase screws
that will fit the 5 mm (3/16 inch) in diameter holes before rack
mounting.
• The temperature in the rack must be between 0 °C (32°F) and 40 °C
(104°F).