1
3
P4
NTSC
1
3
P4
PAL
Black
Red
Yellow
S_IN1
S_OUT2
REF_IN
Jumper setting diagram
Coaxial cable connection diagram
After setting NTSC or PAL for the P4 pin of the accessory SDTI board as shown in the jumper setting
diagram, refer to the coaxial cable connection diagram and connect the coaxial cables. The connections
with the board should be made in the following order:
1
Connect the coaxial cable (black) which was connected in step 7 to the S_IN1 connector on the SDTI
card provided with the unit.
2
Connect the coaxial cable (red) which was connected in step 7 to the S_OUT2 connector on the SDTI
board.
3
Connect the coaxial cable (yellow) provided with the unit to the REF_IN connector on the SDTI board.
Remove the 20-pin remote cable shown at right
from the Remote I/O board connector followed by
the 3 screws, then remove the board metal clamp
from the Quick Cutter unit.
(For AJ-DE77H and AJ-DE77D, also remove the 2
screws and the fan as shown in the diagram at
right. It is not necessary to remove the fan’s power
cable.)
Installation
Remove the cable and screw shown in the diagram at
right, then remove the X4PCI board from the slot.
Insert the accessory SDTI board into the slot which had
accommodated the X4PCI board, secure it using the
screw, and connect the cable that was disconnected
from the X4PCI board to the connector of the SDTI
board.
Connect one end of the coaxial cable (yellow), which was
connected in step 11, to the J7 connector on the TRV
interface board.
-5-
Replace the board metal clamp (and the fan for AJ-DE77H and AJ-DE77D) removed in step 12 and
secure it with the 3 screws.
Connect the 20-pin remote cable removed in step 12 to the Remote I/O board connector.
Yellow
J7
Screws
(x3)
Screw
Enlarged view
Enlarged view
Cable
Screws (x2) for AJ-DE77H or
AJ-DE77D only
20-pin remote cable
Board metal clamp
Fan