Check that the power of the AJ-DE77, AJ-DE77H or AJ-DE77D (hereafter referred to as the “Quick
Cutter” ) is OFF.
Remove the four screws securing the top panel of the
Quick Cutter, then remove the panel.
Installation
While referring to the figure on the right, first
disassemble the accessory terminal board, and then
use two screws to secure the board to the right side
of the jack panel and two screws to secure the blank
panel on the left side.
(In the case of the AJ-DE77D, the blank panel is not
attached because the SDI terminal board is already in
place on the left side.)
After installation, the panels should appear as shown
in the figure below.
Connect the red coaxial cable provided with the
board to the SDTI terminal board OUT and the black
coaxial cable to the SDTI terminal board IN.
-3-
SDI
IN
OUT
AJ-DE77
AJ-DE77D
AJ-DE77H
Jack panel
(AJ-DE77 or AJ-DE77H)
Screws (x6 for
each side panel)
Screws (x7)
Screws (x4)
Blank panel
Remove the 12 screws securing the two side panels
of the Quick Cutter, then remove the panels.
Remove the seven screws securing the jack panel,
then remove the jack panel from the unit.
(It cannot be completely detached because its cable
remains connected.)
Remove the four screws securing the blank panel,
then remove the blank panel from the unit. (Remove
the two screws in the case of the AJ-DE77D.)
Enlarged view
Enlarged view
Before installation
SDI
IN
OUT
SDTI
IN
OUT
SDTI
IN
OUT
AJ-DE77
AJ-DE77D
AJ-DE77H
Blank panel
After installation
