YE110 Instruction
- 1 -
Hardware Installation
In order to successfully install the YE110 digital interface card into your PC, please
follow these directions carefully. Otherwise, your hardware maybe will not function
properly and could become damaged.
The YE110 card has one RJ45 port and two status LEDs. The port is used for connecting
E1, T1 or J1 cables. The two LEDs serve as status LEDs.
Steps
1. Power down your computer.
2. Check the jumper setting to ensure it matches your requirement. The default setting
is E1 mode. If taking out the jumper, the card will be T1 mode.
3. Insert the card into a PCI slot.
4. Plug the E1 or T1 equipment cable into the RJ45 port.
After following these steps, hardware installation is complete.
Figure 1: E1 PCI Card
