Panasonic AJ-PX270EJ, Руководство по эксплуатации

Страница: 34 / 190

– 34 –
Chapter 3 Preparation — P2 card
Removing a P2 card
Fig. 1 Fig. 2
1
Open the card slot cover.
2
Remove the card.
f
microP2 memory cards
- Press in the microP2 card further into the camera and let go.
- The microP2 memory card is released from the card slot, and the microP2 memory card can be removed.
f
P2 memory cards
- Lift the eject button (Fig. 1), and press in. (Fig. 2)
@ @ NOTE
t
After insertion, do not remove the P2 card while it is being accessed or recognized (the P2 card access LED is flashing orange). Doing so may result
in a malfunction.
t
If the P2 card is removed while being accessed, [TURN POWER OFF] is displayed on the LCD monitor screen or the viewfinder screen, and the tally
lamp or other warning is displayed. Also, all P2 card access LEDs flash rapidly in orange. Turn off the power. (page 176)
t
If the P2 card is removed while being accessed, clips on it may become irregular. Check the clips and restore them, if required. (page 104)
t
If the P2 card being formatted is removed, formatting of the P2 card is not guaranteed. In this case, [TURN POWER OFF] is displayed on the LCD
monitor screen or the viewfinder screen. Turn off the power and then back on again, and reformat the P2 card.
t
If a P2 card is inserted into another slot during playback, the inserted card is not recognized and the P2 card access LED does not light. The P2 card
starts to be recognized when playback ends.
t
Even if a P2 card is inserted in a vacant card slot during recording, the P2 card may not be recognized immediately in the following instance:
- Immediately after a pre-recording
- Immediately after a recording slot is switched
t
The P2 card access LED can be set to continuously off in the main menu → [OTHER FUNCTIONS] → [ACCESS LED]. In this case, turn off the power
before removing the card, or after the card is inserted or after operation (recording, playback, etc.) has stopped, and wait for the charging to complete
before removing the card.
Preventing accidental erasure
In order to prevent erasing the recorded contents of the P2 card by mistake, turn the write protect switch on the P2 card to the Protect side (or the LOCK
side).
Write-protect switch Write-protect switch
@ @ NOTE
t
Write-protect switch can be switched while the card is being accessed (during recording or playback), but does not take effect until accessing of the
card stops.
P2 card access LEDs and status of P2 cards
P2 card access LED P2 card status Mode check display*
Is illuminated green Recording possible Reading/writing are both possible. [ACTIVE]
Is illuminated orange Recording target
Reading/writing are both possible. The card is currently
the recording target (including loop recording).
[ACTIVE]
Flashing orange Accessing card Reading/writing are currently being performed. [ACCESSING]
Flashing orange rapidly
The card is being
recognized.
The P2 card is being recognized. [INFO READING]