Panasonic AJ-PCS060G - DVCPRO - Data Storage Wallet, Руководство по эксплуатации

Страница: 30 / 96

E-29
After clearing the error display
1)
,
try formatting the card again. If
the error persists even after this,
contact the place of purchase.
The data format isn't standard.
After clearing the error display 1) ,
you can resume use.
For further details about P2
cards, contact the place of
purchase.
12
13
An unusable P2 card has
been inserted.
After clearing the error display
1)
,
restore a clip using a P2 camera-
recorder or other device before use.
There is a clip that needs to
be restored on the P2 card.
11
ERROR LED display
Errors that may affect the unit are indicated as follows. Investigate the status and take these
corrective actions.
, , : LED lit , , : LED flashing
R : red OR : orange
REMAIN
R
R
Status
The internal HDD temperature
is out of operating range.
Corrective Action
Turn the unit OFF and allow it to
cool down before use.
R
R R
The unit is warming up when [E2]
flashes. Go to a warmer area.
R R The battery is low. Recharge the battery pack.
R
R R R R
The voltage is abnormally low.
Recharge the battery pack.
(Under these conditions, the unit
immediately shuts off.)
R
R R
At the start of copying, there is
not enough HDD space.
After clearing the error display 1) ,
format the internal HDD. If it
contains data you need, back up
the data on a different storage
media before formatting.
R R R
At the start of copying, a P2
card is not inserted. After clearing the error display 1) ,
insert the P2 card, and copy.
R R R
At the start of copying, a
vibration occurred.
After clearing the error display 1) ,
place the unit on a stable
surface.
After the vibration has stopped,
you can resume use.
R
R R
At the start of copying, an
error other than insufficient
HDD space, a missing P2
card, vibration, and the like
has occurred.
R R
During copying, an error has
occurred. (Other than if the P2
card has been pulled out)
After clearing the error display 1) ,
try copying the data again. If the
error recurs, switch P2 cards and
try copying again. If the error
persists even after this, contact
the place of purchase.
A formatting error has
occurred with the P2 card.
(Write-protected)
After clearing the error display
1)
,
set the write-protect switch to the
opposite side from the
PROTECT position.
(See page E-14)
R R
1
2
3
4
5
6
7
8
9
10
No.
1) To clear the error display, press the [POWER] button and [CANCEL] button together.