Panasonic AJ-HDC27VP, Руководство по обслуживанию

Страница: 549 / 741

INF-42
17-4-4. Manual compensation procedure
In case it couldn’t compensate all blemish in automatic compensation, it is also possible to perform blemish
compensation manually by using cursor. Following shows concrete manual compensation procedures by the
case required.
I ) Manual compensation for position which was not detected automatically
1. Close LENS iris and then execute “ABB” by front switch.
2. Open the “<DEFECT COMPENSATION> page” in CAM SERVICE level.
3. Set “COMP ON GAIN” item to desired gain value. (Compensation works in the gain beyond the value set
up in this item.)
4. Open the “<ENTRY (MANUAL) page>” in CAM SERVICE level.
5. Set menu items are shown below.
DEFECT SIZE : 3
GAIN : OFF
6. Set “DEFECT COLOR” item to R / G / B or Y, according to color of blemish. (If two or more color of
blemish appear in the same position, select “Y”.)
<ENTRY (MANUAL)>
→ → → →
H CURSOR COARSE
H CURSOR FINE
V CURSOR COARSE
V CURSOR FINE
DEFECT SIZE
DEFECT COLOR
GAIN
OFFSET LEVEL A
OFFSET LEVEL B
ENTRY
CANCEL : 03
: 80
: 02
: 80
: 3
: Y
: OFF
: 100
(*2)
: 100 (*2)
: OFF
: OFF
Figure Ble-4 ENTRY (MANUAL) page
7. Observe TV-monitor and then adjust “H CURSOR COARSE and FINE” item so that the H cursor position
comes to target blemish.
8. Observe TV-monitor and then adjust “V CURSOR COARSE and FINE” item so that the V cursor position
comes to reduce the blemish.
9. Set “ENTRY” item to ON.
10. When “ENTRY” character appears on the lower right of the screen, data store will be completed.
11. Close menu screen and then turn off the power of the Unit.
NOTE:
*
2
”OFFSET A, B” menu items don’t work in current camera system control software Version T1.01-00-0.01, as of March/ ’01.
(A future schedule is undecided.)