Panasonic AFPG951T34, Руководство пользователя

Страница: 122 / 332

FP Σ User's Manual
7.2 Function Specifications and Restrictions
105
7.2.4 Restrictions
Restrictions on channels
The maximum counting speed of the high-speed counter function and the maximum output
frequency of the pulse output function are determined by the number of channels used and
the combination of the two functions. The same channel cannot be used by more than one
function.
REFERENCE
Please refer to the specifications for the exact values of maximum counting
speed and maximum output frequency. See "Maximum counting speed and
output frequency" on page 280.
Restrictions on I/O allocations
• The inputs and outputs cannot be allocated to more than one function.
•
Inputs and outputs that have been allocated to a high-speed counter or pulse output
function cannot be used as normal inputs or outputs. Exceptions:
-
If no reset input is used in the high-speed counter function, X2 and X5 can be
used as normal inputs.
-
If no deviation counter clear output is used in the pulse output function, Y2 and Y5
can be used as normal outputs.
Restrictions on instructions
•
When using the pulse output instructions F171 , F172 , F174 , and F175 specify the
initial frequency to 30kHz or less. Otherwise, the first pulse may be lost.
• The high-speed counter control flag (e.g. sys_bIsHscChannel0ControlActive) and the
pulse output control flag (e.g. sys_bIsPulseChannel0Active) are assigned to the same
internal relay (e.g. R903A). Therefore, when a high-speed counter instruction or a
pulse output instruction is executed, both the high-speed counter control flag (e.g.
sys_bIsHscChannel0ControlActive) and the pulse output control flag (e.g.
sys_bIsPulseChannel0Active) for the channel used are TRUE. No other high-speed
counter instruction or pulse output instruction can be executed as long as this flag is
TRUE.
• The status of the high-speed counter control flag or pulse output control flag may
change while a scan is being carried out. For example, if the flag is used more than
once as an input condition, different statuses may exist within one scan. To ensure
proper execution of the program, the status of the special internal relay should be
copied to a variable at the beginning of the program.
•
Executing the circular interpolation control instruction F176 sets the circular
interpolation control flag (sys_bIsCircularInterpolationActive) to TRUE. The status of
this flag is maintained until the target value is reached (even if the execution condition
is no longer TRUE). During this time, other pulse output instructions cannot be
executed.