Panametrics DigitalFlow XGS868i, Руководство для стартапов, Страница: 39 / 86

DigitalFlow™ XGS868i Startup Guide 31
Chapter 2. Initial Setup
2.4.1.1 Selecting Volumetric Units
1. Scroll to the desired Volumetric Units for the flow rate display and press [Enter] . Table 6 lists the available
volumetric units.
2. Scroll to the desired unit of Volumetric Time (from seconds to days), and press
[Enter] .
3. Scroll to the desired number of
Vol Decimal Digits (digits to the right of the decimal point) in the volumetric flow
display, and press [Enter] .
2.4.1.2 Selecting Totalizer Units
4. Scroll to the desired Totalizer Units for the flow rate display and press
[Enter]
. Available units are listed in Table 6.
5. Scroll to the desired number of
Tot Decimal Digits (digits to the right of the decimal point in the totalized flow rate
display) and press [Enter] .
6. Do one of the following:
• If MASS FLOW is ON, proceed to
Selecting Mass Flow Units on page 35.
• If MASS FLOW is OFF, the meter returns to the
Global PROGRAM
window. Press
[Escape]
and scroll to
CH1
to continue
setup programming.
Note:
To activate mass flow, refer to the Programming Manual. The following prompts appear only if mass flow is
activated for both channels.
Table 6: Available Volumetric/Totalizer Units
English Metric
ACF = Actual Cubic Feet ACM = Actual Cubic Meters
KACF = Thousands of ACF KACM = Thousands of ACM
MMACF = Millions of ACF MMACM = Millions of ACM
SCF = Standard Cubic Feet SCM = Standard Cubic Meters
KSCF = Thousands of SCF KSCM = Thousands of SCM
MMSCF = Millions of SCF MMSCM = Millions of SCM