Panametrics DigitalFlow XGS868i, Руководство для стартапов, Страница: 24 / 86

Chapter 1. Installation
16 DigitalFlow™ XGS868i Startup Guide
1.7.5.3 Wiring a 0/4-20 mA Analog Inputs Option Card (cont.)
Before making any connections, complete the steps in Preparing for Wiring on page 13. Wire the analog inputs as
shown on the label in the rear cover (see Figure 11 on page 24).
Note:
The analog inputs option card can be calibrated with the Model XGS868i’s built-in analog outputs. However,
be certain that the analog outputs have been calibrated first. See Chapter 1, Calibration, in the Service
Manual
for the appropriate procedures.
1.7.5.4 Wiring a Totalizer/Frequency Outputs Option Card
Each totalizer/frequency outputs option card provides two or four outputs (designated as A, B, C, and D) that can be
used as either totalizer or frequency outputs.
Before making any connections, complete the steps in
Preparing for Wiring on page 13. Then, wire this option card in
accordance with the connections shown on the label in the rear cover (see Figure 3 on page 6 and Figure 11 on
page 24). Figure 6 shows sample wiring diagrams of a totalizer output circuit and a frequency output circuit. Refer to
Electrical Specifications on page 53 for load and voltage requirements.
Figure 6: Totalizer/Frequency Outputs Wiring
OUT
RTN
IN
Common
Load
Volts -
(Common)
Volts +
(Int. Pwr. Sup.)
OUT
RTN
+5V
200
:
Transmitter
Transmitter
Pulse Counter
Frequency Counter
Totalizer Output
Frequency Output