Panametrics CTF878, Руководство для стартапов

Страница: 55 / 108

Model CTF878 Startup Guide 47
Chapter 3.
Note: The Transducer, Pipe, Fluid and Path parameters are categorized under the same Transducer/Pipe menu, as
shown in Figure 30 below. You can be more time-efficient by programming the parameters in all four entries
under Transducer/Pipe before exiting the menu.
When you are highlighting a parameter in one of the four entries, and you wish to go to another entry:
1. Use the [

] key to scroll up to the current tab (the entry that you are under).
2. Press the [

] or [

] key to select the parameter you want to access, then press [
ENTER
].
3.1.5.2 Entering Transducer Parameters
To enter the Transducer option, scroll to the Transducer tab on the Program Menu and press [ENTER] . The screen
appears similar to Figure 30 below. To step through each parameter, press the [

] key. Refer to the
Program Menu
Map, Figure 46 on page 65.
Note: If the CTF878 does not scroll to a particular parameter, the parameter is not necessary for that transducer
type.
.
Figure 30: Transducer Option Window
The next prompt asks you to enter the transducer number (printed on the transducer itself), or to specify that you are
using a special application transducer.
1. From the Type prompt, press the [

] key to reach the Transducer prompt, and press [ENTER] .
Transducer
Transducer/Pipe
Pipe Fluid Path
#310 (Shear)
0.500 0.471
Transducer
Frq Up/Dn MHz
OK Cancel
° 35 Wedge Ang
Wedge Tmp 45 °C
Wedge SS 2480 m/s
Transducer/Pipe
Transducer