Panametrics CTF878, Руководство для стартапов, Страница: 14 / 108

Chapter 2.
6 Model CTF878 Startup Guide
• CPL-16 Couplant (not shown)
Figure 2: Parts for a Typical CTF878 System
2.1.4 Tools for Installation
Before you begin installing the
Model CTF878 Clamp-On Tag Flowmeter, see Table 2-1 below for a list of required
tools.
Tool Used:
Multimeter to check the voltage (if required).
Knife or Box Cutter to cut the damping material to size.
Standard
Screwdriver
to mount the electronics console, etc.
Phillips Screwdriver to remove and replace the plastic
shroud.
Wire Cutter to cut cables and wires.
Wire Stripper to prepare wires for TB connections.
Std. Screwdriver
(miniature)
to connect the cable wires to terminal
blocks.
Sandpaper to smooth out the surface of pipe.
Cloth to clean the surface of the pipe.
Tape Measure to lay out fixture/transducers placement.
Conduit Boxes
CFT- PI Clamping Fixture
Transducers
CTF878 Flowmeter
CFT-V Clamping Fixture
for pipes
for pipes larger than 12” O.D.
6” to 12” O.D.
Mounting
Chains