9
1-800-634-7328 DirectSupply.com
4. Connect the end of the external manifold to the alternating pressure
pump. The mattress operation will not be affected by the hose orientation.
Ensure the air lines are not “kinked” or “twisted.”
5. Ensure the electrical power switch on the side of the pump is in the OFF
position then plug in the power cord. Change the ON/OFF switch from the
OFF position to the ON position. The POWER ON lamp should now be
illuminated.
6. Allow the mattress 45 minutes to inflate fully.
7. After preparing the mattress surface with appropriate linens (not included),
place the resident on the mattress. Initially set the PRESSURE CONTROL
knob to Low. Increase if necessary for resident comfort. LINEN NOTE:
Deep-pocketed sheets are recommended (not included). Multiple layering
of linens or under pads beneath the resident can negatively affect the
mattress’s pressure management capabilities and should be avoided
unless recommended by a caregiver.
•
CAUTION:
Be careful not to puncture the mattress with needles or sharp
instruments. This may result in loss of integrity of the cover or internal air system.
•
NOTE
– This product is only one element of care in the prevention and treatment
of pressure ulcers by medical professionals and skilled caregivers to assist in the
treatment and prevention of pressure ulcers. This product is not designed to and
cannot replace good caregiving practices and treatment, including but not limited to:
• Appropriate nutrition and hydration, frequent positioning, routine skin
assessment, wound treatment, infection control, and other generally accepted
standards of care and prevention
• Adequate training for and precautions by staff personnel for bed entrapment
• Selection of an appropriate bed system to use with the product and proper
maintenance and use of the product
• Testing of the product before each use
Directions for Use