PALSON DONNA, Руководство по эксплуатации

Страница: 7 / 28

6 7
Preheating
1. Rest the plate on a flat, smooth surface and plug the appliance into the mains.
2. Turn on, set to the required temperature and allow the plates to heat; they take about 60-90 seconds to heat.
3. The LED stops blinking and stays lit continuously when the set temperature has been reached.
Temperature settings
Press the “+” button to increase the temperature setting. Press the “-” button to lower the temperature setting. The
temperature LEDs blink to indicate the temperature chosen. When the required temperature setting is reached, the
temperature LEDs stop blinking and remain lit continuously.
Hair type Temperature setting
Very thick and wiry (High) 200º C
Thick, bushy, hard to straighten (Medium/High) 180ºC
Normal, in good condition (Medium) 160ºC/140ºC
Very fine, fragile, light-coloured (Low) 120º C
Note: If the operating LED is lit but all the temperature LEDs are off, the plates will not heat. You must press the “+/-”
button to heat the plates.
Warning: Be very careful when using the straightening plates as they become very hot at the highest temperature
setting.
Styling
To style, the hair must be clean. The straightening plates are designed for use with wet or dry hair. You can use styling or
straightening products with these plates.
1. Work with sections of hair that do not exceed 6 cm wide and 1 cm thick.
2. Place the hair between the hot plates and press the plates firmly together.
3. Hold this position for a few seconds and pull slightly on the hair to keep it taut.
4. Release the pressure and allow the hair to come free of the plates.
CARE AND CLEANING
This product contains parts that cannot be repaired by the user. Take to qualified service technicians.
Cleaning
1. Unplug the appliance and allow the straightening plates to cool. The plates should only be cleaned when fully
cooled.
2. Use a soft, slightly damp cloth to clean the handle. Do not allow water or any other liquid to enter the handle.
3. If material should build up on the plates, clean with a mild, gentle soap or a special cleaning fluid and wipe with a soft
cloth.
STORAGE
1. Unplug the appliance, allow to cool and store in a clean, dry place.
2. Coil the power cord loosely .
3. Never coil the power cord around the appliance; this will cause wear and premature cord breakage.
4. Never strain the power cord in the area where it enters the handle. This will cause rubbing and breakages.
5. Never hold the appliance by the power cord.
Thank you for choosing one of our products.