14
Palram Americas
• Measuring/Cutting Roof Panels for Left/Right Side of Roof
IF YOU DO NOT NEED TO RIP CUT YOUR FINAL TWO ROOF PANELS, SKIP TO PAGE 17.
You will rip cut the final left and right Roof Panels to fit (if required) BEFORE you install
the End Profile Bases. See below.
Set the uncut end Roof Panel in place. On the Roof Panel, note the center line of the end rafter.
Then subtract 3/8" and mark that as your rip line along the Roof Panel.
END
RAFTER
CENTER
LINE
MINUS
3/8"
1
Measure twice, cut once!
2
Bring the sheet to the ground. Cut the Roof Panel along the rip line.
3
Cut the Panel Gasket to the length of the Roof Panel (if needed).
Then add the cut Panel Gasket to the cut edge of the Roof Panel.
THE RIP LINE IS THE
RAFTER CENTER LINE
MINUS 3/8"
INSTALLATION
NOTE: PROFILE
CLOSURE NOT
SHOWN IN
DRAWING
