Version 1.1.4 dated 2015-3-30
Page 25
Original operating instructions
BF46 Vario | BF46TC
US
3.8
First commissioning
ATTENTION!
Before commissioning the machine check all screws, fixtures resp. safety devices and
tighten up the screws if necessary!
WARNING!
Risk by using improper tool holders or operating them at inadmissible speeds.
Only use the tool holders (e.g. drill chuck) which were delivered with the machine or
which are offered as optional equipment by
company
.
Only use tool holders in the intended admissible speed range.
Tool holders may only be modified in compliance with the recommendation of
company
or of the manufacturer of the clamping devices.
WARNING!
When first commissioning the mill drill by inexperienced staff you endanger people and
the machine.
We do not take any liability for damages caused by incorrectly performed commission-
ing.
"Qualification of personnel“ on page 10
3.8.1
Power supply
Connect the electrical supply cable.
Check the fusing (fuse) of your electrical supply according to the technical instructions regard-
ing the total connected power of the mill drill.
3.8.2 Cleaning and lubricating
Remove the anti-corrosive agents on the mill drill which had been applied for transportation
and storage. Therefore, we recommend you to use paraffin.
Do not use any solvents, cellulose thinner or any other cleaning agents which might affect
the coating of the mill drill when cleaning the machine. Observe the indications and notes of
the manufacturer for cleaning agents.
Oil all blank machine parts using an acid-free lubricating oil.
Lubricate the mill drill according to the lubricating plan.
"Inspection and maintenance“ on page 46
Check if all spindles are running smoothly. The spindle nuts are re-adjustable.
Disassemble the V-ledges of the cross table and clean the ledges from the anti-corrosive
agent.
"V-ledges“ on page 49
