Version 1.1.4 dated 2015-3-30
Page 15
Original operating instructions
BF46 Vario | BF46TC
US
1.12
For your own safety during operation
WARNING!
Before activating the mill drill assure yourself that this will neither endanger other
persons nor cause damage to equipment.
Avoid any unsafe working practices:
Make sure that nobody is endangered by your work.
The instructions mentioned in these operating instructions have to be strictly observed dur-
ing assembly, operation, maintenance and repair.
Wear safety goggles.
Switch off the mill drill before measuring the workpiece.
Do not work on the mill drill, if your concentration is reduced, for example, because you are
taking medication.
Stay on the mill drill until the working spindle has come to a complete standstill.
Use the prescribed personnel protective equipment. Make sure to wear a well-fitting work
suit and, if necessary, a hairnet.
Do not use protective gloves during drilling or milling work.
Disconnect the shock-proof plug from the outlet before replacing the tool.
Use appropriate auxiliary materials to remove drilling and milling chips.
Make sure that nobody is endangered by your work.
Safely and firmly clamp the workpiece before switching on the mill drill.
We specially point out the specific dangers when working with and on the mill drill.
1.13
Disconnecting and securing the mill drill
Switch off the mill drill with the main switch before starting any maintenance and repair works.
1.14
Using lifting equipment
WARNING!
The use of unstable lifting and load suspension gear that might break under load can
cause severe injuries or even death.
Check that the lifting equipment and load-suspension gears are of sufficient load
capacity and are in perfect condition.
Observe the accident prevention regulations issued by your Employers Liability
Insurance Association or other competent supervisory authority, responsible for your
company.
Fasten the loads properly.
Never walk under suspended loads!
