7
G
E
T
T
IN
G
S
T
A
R
T
E
D
S
A
F
E
T
Y
/
S
P
E
C
IF
IC
A
T
IO
N
S
A
S
S
E
M
B
L
Y
/
IN
S
T
A
L
L
A
T
IO
N
O
P
E
R
A
T
IO
N
T
R
O
U
B
L
E
S
H
O
O
T
IN
G
M
A
IN
T
E
N
A
N
C
E
/
R
E
P
A
IR
OPERATION
Always wear safety glasses complying
with U.S. ANSI Z87.1 before beginning any
power tool operation.
Do not operate this machine before
properly lubricating the machine. Failure
to lubricate the machine before using can cause damage to
the machine.
If the temperature exceeds the maximum
operating temperature (see ) wait until
cool.
Do not use the press with no load and when
the piston rod is on the up dead position.
NOTE:
The machine is adjusted to produce proper pressure at
the factory.
The machine’s functional parts
To properly operate the Model 9661614 Hydraulic Press, you
must familiarize yourself with all of the machine’s controls.
Using the press
1.
Set the directional valve handle to the center position before
starting the pump.
2.
Place the part to be pressed on the worktable.
3.
Ensure the cap of the tank, below the motor, is secure.
4.
Press the “On” button.
5.
Use the 3-position handle to control the direction of the
press. Left for up; middle for stop; right for down.
6.
Release the “On” button by pressing the “Off” button when
done.
Adjusting the table height
1.
Unload the table of all extra items.
2.
Lift the table support beam on one side. We recommend
asking for assistance in holding the beam.
3.
Extract the support pin as shown below.
4.
Insert the pin into the next adjacent hole, either above or
below the original hole. Make sure to insert the pin all the
way through both the front and back of the Electric Hydraulic
Press frame.
5.
Then ease the support beam back onto the pin.
6.
Repeat all previous steps for the opposite side.
7.
Repeat until the desired height is achieved.
