3
G
E
T
T
IN
G
S
T
A
R
T
E
D
S
A
F
E
T
Y
/
S
P
E
C
IF
IC
A
T
IO
N
S
A
S
S
E
M
B
L
Y
/
IN
S
T
A
L
L
A
T
IO
N
O
P
E
R
A
T
IO
N
T
R
O
U
B
L
E
S
H
O
O
T
IN
G
M
A
IN
T
E
N
A
N
C
E
/
R
E
P
A
IR
GETTING STARTED
Save this manual
You will need this manual for the safety warnings and precau-
tions, assembly instructions, operating and maintenance
procedures, parts lists and diagrams. Keep your invoice with this
manual. Write the invoice number on the inside of the front cover.
Keep this manual and invoice in a safe and dry place for future
reference.
Structural requirements
Make sure all supporting structures and load attaching
devices are strong enough to hold your intended loads.
If in doubt, consult a qualified structural engineer.
Electrical Requirements
•
Requires
23
0V at 60 Hz, with a standard deviation of 10%
•
A plug, rated for
23
0V,
13
A, and 2.2
K
W, is required to be
wired. Ensure the ground wire(green) is correctly
wired to the ground of the plug. It does not matter which side
of the plug the two black wires are wired to.
Tools needed
Standard professional
mechanic’s hand tool set (i.e. hammer,
screwdrivers, wrenches,
socket wrenches, pliers, etc.).
UNPACKING
When unpacking, check to make sure all parts listed below are
included. If any parts are missing or broken, please contact your
local retailer.
IMPORTANT:
Many unpainted steel surfaces have been
coated with a protectant. To ensure proper fit and operation,
remove the coating. Coating can be easily removed with mild
solvents, such as mineral spirits, and a soft cloth. Avoid getting
solution on paint or any of the rubber/plastic parts. Solvents may
deteriorate these finishes. Use soap and water on paint, plastic
or rubber components. After cleaning, cover all exposed surfaces
with a light coating of oil.
Never use highly volatile solvents. Avoid
getting cleaning solution on paint as it
may tend to deteriorate these finishes. Use soap and water
on painted components.
Package Contents:
Main body
1
Cylinder
1
Motor
1
“V” type iron
2
Seal rings
1
Instruction book
1
Packing list
1
Conformity certificate
1
Unpack
Remove all the over packing materials, but leave unit
attached to its pallet. Do not discard packing materials
until after the machine has been inspected for damage and
completeness. Locate loose parts and set aside.
Inspect
After unpacking the unit, carefully inspect for any
damage that may have occurred during transit. Check
for loose, missing or damaged parts. Shipping damage
claims must be filed with the carrier.
All tools should be visually inspected before use, in addition to
regular periodic maintenance inspections.
