ASSEMBLY
Refer to Figures 3 - 12 and 22.
MOUNT COLUMN ASSEMBLY TO BASE (80341A)
Refer to Figures 3 and 23.
•
Place base on flat level surface.
•
Mount column assembly to base using four hex head bolts, lock
washers and flat washers.
•
Push supporting yoke (Ref. No. 6) into holes at rear of base (Ref.
No. 1) with bent portion of yoke facing down.
•
Use strap, washers, bolts and nuts (Ref. Nos. 2 - 5) to secure yoke
in position.
MOUNT COLUMN ASSEMBLY TO BASE (80342A)
Refer to Figure 4.
•
Place base on flat level surface.
•
Mount column flange to base using four hex head bolts, lock
washers and flat washers.
•
Insert column into flange. Push column down until it seats in
flange. Secure column in position with the two set screws.
MOUNT TABLE BRACKET ASSEMBLY (80341A)
Refer to Figures 5 and 6, page 4 and 5.
•
Make sure worm gear is in the table bracket and engages pin-
ion teeth.
•
Place rack inside table bracket. Slide rack into the slot in the
bracket so that rack teeth engage the pinion gear in the bracket.
Large non-machined portion of rack should be at top.
4
Palmgren Operating Manual & Parts List
80341A & 80342A
Column
Flange
Rack
Table Bracket
Assembly
Figure 5 – Position Table Bracket Assembly on Column
Figure 3 – Mount Column Assembly to Base (80341A)
Hex Head Bolts
Column Assembly
Base
Figure 4 – Mount Column Flange to Base
Column
Hex Head Bolts
Set Screw
Flange
Base
