MOUNTING TO WALL WITH TAPE
For glaze tile, painted metal or unpainted metal walls
Thoroughly clean wall surface with included wipe and
let dry completely. (see figure 9) For silicone build-up,
use a pumice-type cleaner or grout cleaner to clean
the surface. Tape will not perform satisfactorily if wall
surface is porous like brick or wood.
Peel paper from back of tape (supplied). (see figure 10)
Press dispenser firmly to the wall and hold for at least
30 seconds to make sure tape has completely adhered
to the wall.
Open dispenser and remove refillable bottle.
(see figure 11)
Locate dispenser above a sink or counter.
Recommended never locating where spillage can fall on
floor creating hazardous condition.
Mount dispenser at least 12" above any surface to
prevent activation of sensor.
Installer will be held responsible for proper installation.
To be in compliance with ADA regulations, the dispenser
should be mounted no more than 48" from the ground.
MOUNTING WITH SCREWS
For porous surfaces like brick or wood
Use included SCREWS AND ANCHORS or other appropriate
hardware based on surface type.
Open dispenser and remove refillable bottle. (see figure 11)
Using the dispenser, mark hole locations on wall.
(see figure 12).
Drill 1/8" diameter holes for anchors and screws or other
hardware (see figure 13). Attach dispenser to wall with
appropriate hardware.
Install 4 c-cell alkaline batteries (See Battery Care
Instructions) and close dispenser. (see figure 14)
Replace refillable bottle.
Tape mount installation should be
allowed to set for 24 hours before filling.
Maintenance Instructions/Battery Replacement
It is important to clean and maintain dispenser and check
battery on a regular, scheduled basis. Failure to do so can
result in dispenser malfunction.
Open dispenser using KEY and remove refillable bottle.
Flush bottle and pump mechanism thoroughly with warm
water to remove residue and contaminates. Refill and
replace bottle. Close dispenser. (see figure 7)
Cleaning all touch-points on dispenser with a disinfectant
should be part of a regular cleaning schedule.
Periodically give the dispenser an overall cleaning. All
internal and external parts should be cleaned thoroughly.
Sensor lens (located underneath dispenser) should be
cleaned regularly with a damp cloth. (see figure 8)
Check Battery Indicator Light (see figure 4) to verify battery
life (See Battery Care Instructions).
TO FILL DISPENSER
CAUTION: For dispenser to work properly, use soap
foam formulated for foaming soap dispensers.
Open dispenser using KEY. (see figure 1)
Remove cap from bottle (see figure 5) and fill with
soap to fill line (see figure 6). For convenience, bottle
can be filled in dispenser or removed prior to filling.
Replace cap and close dispenser.
DISCLAIMER: Not responbible for non-foam soap
use that results in ineffective dispenser operation or
clogging. Soap containing any type of scrubbers will
cause the dispenser to leak and eventually fail.
Figure 1
Figure 5
Figure 6
Figure 7
Figure 8
Figure 10
Figure 11
Figure 12
Key
Figure 9
Figure 13
Figure 14
