Pallipartners 970P, Руководство пользователя

Страница: 8 / 20

6
Button
•
VOL-(backlight) button:
VOL-(backlight) button: Short press to regulate the volume
circularly. Long press and hold the button for about 2 seconds,
and the backlight is lit for about 10 minutes.
• POWER button:
Power button: power on/off
• MODE-SENS button:
1. Press the MODE button, cycle selection in four ways.
A-M: All metal mode, the detector will respond to all metal.
DISC: Discrimination mode, in this mode you can eliminate
certain kind of metal then the detector won't respond to it.
MEMORY: Remember some kind of metals you choose, and will
only respond to this metal.
JEWELRY: Eliminate iron, it won't respond to iron, but it will
respond to other metals.
2. Press the SENS button, ( , ) buttons to adjust the sensitivity.
• ( , ) button: There are two functions.
1. Press SENS button, the sensitivity cursor will flash, and the ( , )
button is used to adjust sensitivity.
2. In DISC mode, the ( , ) button is used to set the discrimination
targets.
• P-P button: Press the “P-P” button, and the detector will convert
to PINPOINT mode, to locate the target accurately. Press the
"P-P" button once again, to exit the PINPOINT mode.
QUICK- START
1. Lay the detector
Put the detector on a wooden or plastic table, and let the search
coil stretch out of the table about 30cm, keep away from walls,
ceilings and floors, turn off all kinds of electrical appliances that
will cause electromagnetic interference, remove watches and
rings from hands. (see Fig 8)