Palfinger C1500L, Руководство пользователя, Страница: 34 / 435

31
Installing lifting mechanism

Mount the lifting mechanism as described in section „Installing
lifting mechanism“ from page 24.

Then precisely align the console plates ( 2 ) with respect to height
and width to the chassis.

Fix the console plates to the vehicle chassis and tighten the hex.
nuts (
5 ).

Optional: Screw the locking clamps ( 7 ) by means of the hex.
screw and nut to the stand tube ( 1 ).

Note the following tightening torques.
The bolts must be regularly retightened regularly:
• after 3 weeks in operation
• after 3 months in operation
• check and if necessary retighten half-yearly
If the battery cable is not directly connected to the battery
and the ground runs over the vehicle chassis, it may be necessary
to fabricate a ground cable from the delivered cable lugs
and protective caps.

Cut off the required length of cable from the supplied battery
cable.

Keep the ground cable ( 8 ) as short as possible and attach
it to the ground screw provided on the stand tube.

Before lifting the platform, make sure that the solenoid valves
on the lift cylinder can move freely at the U-section (
6 )
of the bolted console. Otherwise you must turn the coil
on the solenoid valve through 90°.
Table 2
Bolts Tightening torque
Bolt M20x1.5 - St10.9 400 Nm
Bolt M14x1.5 - St10.9 190 Nm
Bolt M10 - St8.8 50 Nm
NOTE
Before connecting the ground cable, find out from the vehicle maker whether
this is possible.