![Palazzetti ecopalex 64 Скачать руководство пользователя страница 38](http://html1.mh-extra.com/html/palazzetti/ecopalex-64/ecopalex-64_installation-user-and-maintenance-manual_747751038.webp)
38
00 477 0152 -04/2017 - PALAZZETTI - PN - I
TALY
Fig. 5.6.1
Fig. 5.7
Fig. 5.8.1
INSTALLATION
6.7
OPTIONAL FRONT FRAME KIT
Front frame kit, used to
¿
x and blend
Appliance
in with
the structure of the
¿
replace where it is recessed in.
During the preinstallation phase, it will be necessary to
¿
rst
¿
x the pro
¿
les on the side edges and upper edge
of the
Appliance
using the relative screws (Fig. 5.6:
A
plugs -
B
Air outlet collars -
C
Front frame supports).
If you are not going to use the front
¿
ller frame, leave a
gap of at least 1 cm for air to circulate.
6.8
CENTRAL FILLER FRAME (OPTIONAL)
Measure the side panels and the front panel. If
necessary remove them with shears;
¿
x them to the
pro
¿
les attached previously to
Appliance
(Fig. 5.6.1)
with the relative screws. If you are not going to use the
front
¿
ller fame leave a gap of at least 1 cm for air to
circulate.
The slits under the ash box or on the side must never be
obstructed so as not to undermine combustion ef
¿
ciency.
6.9
PUTTING APPLIANCE IN
Before anything else, stand the
Appliance
on the
¿
replace level. Spread a line of
¿
re-sealant paste (that
resists a temperature of 800°C) on the bottom of the
collar (at the top). Move the
¿
replace into the
¿
nal
position. You can make it easier to move by using two
2-3 mm thick metal sheet guides under it, removing
them once the
¿
replace is positioned (Fig. 5.7).
6.10 FITTING THE TELESCOPIC PIPE
This is the case when you are installing the
Appliance
in an existing
¿
replace.
You
¿
rst of all have to open the door, remove the
cast iron smoke diaphragm (Fig. 5.8.1) and pull it out
downwards. Remove the smoke butter
À
y regulator
diaphragm, lifting it
¿
rst on the right and then pulling
it out from the left bush. Now, with one hand, pull the
rod
¿
xed in the telescopic pipe downwards and put it in
place. Lastly, remove any excess ealant from inside
and put the butter
À
y diaphragm back in place as well
as the cast iron smoke diaphragm. The smoke
¿
tting is
now installed.