Palax C900, Инструкция по эксплуатации

Страница: 23 / 37

23 1-2017
Translation
5 USE OF THE FIREWOOD PROCESSOR, CROSSCUT OPERATION
NOTE ! The machine is intended for operation by one person only. Never leave
the machine, which is easy to start, unattended.
5.1 Operating the crosscut saw, before the operation
Cleanse the new circular saw-blade of any protective grease, because a greasy blade ac-
cumulates resin easily, making it heat up, lose its tension and start to jerk.
5.2 During the operation
Exercise caution.
Do not cut slender logs more than one at a time, because if many logs are being cut at
the same time, some of them may twist the blade strongly, causing it to heat up and
lose its tension.
Never stop the rotation of the blade by pressing the blade against the log.
During the crosscut operation, make sure that the log is always supported on the roller.
Make sure that the log stays firmly under the clamp during sawing to keep it reliably in
position on the deck. This is particularly important when sawing crooked trees and,
generally, when the last piece is being cut and the log is short and lightweight.
Cut very crooked trees where they bend. Doing so makes the crosscut operation signif-
icantly easier.
WARNING! Crooked trees may be turned on the deck by the cutting force thus
twisting the blade so strongly that it breaks.
5.3 Cutting to equal length and feeding into the splitting chute
Cut off the undersized piece while there is still sufficiently material for two or three more
pieces of appropriate size left in the billet. The last log must not be longer than the ad-
justed cut-off length.
Use the scale at the edge of the in-feed deck as an aid, Fig. 12.
Fig. 12